Intended place of operation, Legal information – HEIDENHAIN iTNC 530 (340 49x-04) ISO programming User Manual
Page 9
HEIDENHAIN iTNC 530
9
Intended place of operation
The TNC complies with the limits for a Class A device in accordance
with the specifications in EN 55022, and is intended for use primarily
in industrially-zoned areas.
Legal information:
This product uses open source software. Further information is
available on the control under
Programming and Editing operating mode
MOD function
LEGAL INFORMATION soft key
smarT.NC: Positioning strategy for
machining point patterns
smarT.NC Pilot
FCL 2 functions
Description
3-D line graphics
Virtual tool axis
USB support of block devices (memory
sticks, hard disks, CD-ROM drives)
Page 135
Filtering of externally created contours
Conversational
Programming User’s
Manual
Possibility of assigning different depths
to each subcontour in the contour
formula
Conversational
Programming User’s
Manual
DHCP dynamic IP-address
management
Touch-probe cycle for global setting of
touch-probe parameters
Touch Probe Cycles
User’s Manual
smarT.NC: Graphic support of block
scan
smarT.NC Pilot
smarT.NC: Coordinate transformation
smarT.NC Pilot
smarT.NC: PLANE function
smarT.NC Pilot
FCL 3 functions
Description