HEIDENHAIN iTNC 530 (340 49x-04) ISO programming User Manual
Page 698
M109
M110
M111
Constant contouring speed at tool cutting edge
(increase and decrease feed rate)
Constant contouring speed at tool cutting edge
(feed rate decrease only)
Cancel M109/M110
M114
M115
Automatic compensation of machine geometry when working with tilted axes
Reset M114
M116
M117
Feed rate for angular axes in mm/min
Cancel M116
M118 Superimpose handwheel positioning during program run
M120 Pre-calculate radius-compensated contour (LOOK AHEAD)
M124 Do not include points when executing non-compensated line blocks
M126
M127
Shortest-path traverse of rotary axes
Cancel M126
M128
M129
Retain position of tool tip when positioning tilting axes (TCPM)
Reset M128
M130 Moving to position in an untilted coordinate system with a tilted working plane
M134
M135
Exact stop at nontangential contour transitions when positioning with rotary axes
Reset M134
M136
M137
Feed rate F in millimeters per spindle revolution
Reset M136
M138 Selection of tilted axes
M140 Retraction from the contour in the tool-axis direction
M141 Suppress touch probe monitoring
M142 Delete modal program information
M143 Delete basic rotation
M144
M145
Compensating the machine’s kinematics configuration for ACTUAL/NOMINAL positions at
end of block
Reset M144
M148
M149
Retract the tool automatically from the contour at NC stop
Cancel M148
M150 Suppress limit switch message (function effective blockwise)
M200
M201
M202
M203
M204
Laser cutting: Output programmed voltage directly
Laser cutting: Voltage output varies with the distance
Laser cutting: Voltage output varies with the velocity
Laser cutting: Voltage output varies with the time (ramp)
Laser cutting: Output voltage as a function of time (pulse)
M
Effect
Effective at block...
Start
End
Page