Software options – HEIDENHAIN iTNC 530 (340 49x-04) ISO programming User Manual
Page 6
6
Software options
The iTNC 530 features various software options that can be enabled
by you or your machine tool builder. Each option is to be enabled
separately and contains the following respective functions:
Software option 1
Cylinder surface interpolation (Cycles 27, 28, 29 and 39)
Feed rate in mm/min on rotary axes: M116
Tilting the machining plane (Cycle 19, PLANE function and 3-D ROT
soft key in the Manual operating mode)
Circle in 3 axes with tilted working plane
Software option 2
Block processing time 0.5 ms instead of 3.6 ms
5-axis interpolation
Spline interpolation
3-D machining:
M114: Automatic compensation of machine geometry when
working with tilted axes
M128: Maintaining the position of the tool tip when positioning
with tilted axes (TCPM)
FUNCTION TCPM: Maintaining the position of the tool tip when
positioning with tilted axes (TCPM) in selectable modes
M144: Compensating the machine’s kinematics configuration for
ACTUAL/NOMINAL positions at end of block
Additional finishing/roughing and tolerance parameters for
rotary axes
in Cycle 32 (G62)
LN blocks (3-D compensation)
DCM Collision software option
Description
Function that monitors areas defined by the
machine manufacturer to prevent collisions.
Page 96
DXF Converter software option
Description
Extract contours from DXF files (R12 format).
Page 250
Additional dialog language software
option
Description
Function for enabling the conversational
languages Slovenian, Slovak, Norwegian,
Latvian, Estonian, Korean, Turkish, Romanian.