HEIDENHAIN iTNC 530 (340 49x-04) ISO programming - Manual (Page 501)

HEIDENHAIN iTNC 530 501
9.9 Tilting the w
o
rk
ing plane thr
o
ugh axis angle: PLANE
A
XIAL (FCL
3
function)
Input parameters
 Axis angle A?: Axis angle to which the A axis is to
be moved. If entered incrementally, it is the angle by
which the A axis is to be moved from its current
position. Input range: –99999.9999° to +99999.9999°
 Axis angle B?: Axis angle to which the B axis is to
be moved. If entered incrementally, it is the angle by
which the B axis is to be moved from its current
position. Input range: –99999.9999° to +99999.9999°
 Axis angle C?: Axis angle to which the C axis is to
be moved. If entered incrementally, it is the angle by
which the C axis is to be moved from its current
position. Input range: –99999.9999° to +99999.9999°
 Continue with the positioning properties (see
“Specifying the positioning behavior of the PLANE
function” on page 502).
Abbreviations used
Example: NC block
5 PLANE AXIAL B-45 .....
Abbreviation Meaning
AXIAL Axis-shaped