HEIDENHAIN iTNC 530 (340 49x-04) ISO programming - Manual (Page 614)

614 12 Test Run and Program Run
12.9 A
d
aptiv
e
F
e
ed Contr
o
l Sof
tw
a
re
Option (AFC)
Proceed as follows to select and, if required, edit the
.H.AFC.DEP
file:
 Select the Program Run, Full Sequence mode of
operation.
 Shift the soft-key row.
 Select the table of AFC settings.
 Make optimizations if required.
You can also edit the .H.AFC.DEP file in the Programming and
Editing mode of operation. If necessary, you can even delete a
machining step (entire line) there.
Note that the .H.AFC.DEP file is locked against
editing as long as the NC program .H is running.
The TNC then displays the data in the table in red.
The TNC removes the editing lock if one of the following
functions has been executed:
„ M02
„ M30
„ END PGM
In order to edit the .H.AFC.DEP file, you must first
set the file manager so that the TNC can display
dependent files (see “Configuring PGM MGT” on page
637).