HEIDENHAIN ND 221 B v.2 - Manual (Page 16)

16
Parameter Settings / Function
P00 CODE Enter a code number:
9 51 48:
To change the protected
operating parameters
10 52 96: Nonlinear axis error compensation
24 65 84: To lock the keyboard
66 55 44: To show the software version
24 65 82: Distance-to-go display
48 61 53: Input and output of parameter
and compensation value lists
P01 Units of measurement
Display in millimeters
MM
Display in inches INCH
P11 SCL Scaling factor
Scaling factor off
SCALING OFF
Scaling factor on SCALING ON
P12 SCL Scaling factor
Enter a numerical value
0.100000 < P12 < 9.999999
Default setting: 1.000000
P30 DIR Counting direction
Positive counting direction with
positive direction of traverse DIRECT. POS
Negative counting direction with
positive direction of traverse DIRECT. NEG
List of Operating Parameters
List of Operating Parameters
Parameter Settings/ Function
P31 S. PER. Signal period of encoder
0.000 000 01 < P31 < 99 999.9999 µm
Default setting: 10 µm
P33 COUNT Counting mode
0-1-2-3-4-5-6-7-8-9
COUNT 0-1
0-2-4-6-8 COUNT 0-2
0-5 COUNT 0-5
P38 DP POS Decimal places 1)
1 / 2 / 3 / 4 / 5 / 6
(up to 8 for inch display)
P40 COMP. Select encoder compensation
No compensation
COMP. OFF
Nonlinear: up to 64 compensation points for
linear encoders
NONL. COMP
Linear compensation COMP. ON
1) Depends on signal period (P31) and measuring unit (P01)