Polaris 2008 Ranger RZR - Manual (Page 88)

85
MAINTENANCE
Engine Oil
Oil and Filter Change
8. Using a cap-style oil filter wrench, turn the filter counter-clockwise
to remove it.
9. Using a clean dry cloth, clean the filter sealing surface on the crank-
case.
10. Lubricate the o-ring on the new filter with a film of fresh engine oil.
Check to make sure the o-ring is in good condition.
11. Install the new filter and turn by hand until the filter gasket contacts
the sealing surface, then turn and additional 1/2 turn.
12. Remove the dipstick and fill the sump with two quarts (1.9 l) of rec-
ommended oil.
13. Place the transmission in PARK. Apply the brakes.
14. Start the engine. Allow it to idle for one to two minutes.
15. Stop the engine. Inspect for leaks.
16. Re-check the oil level on the dipstick and add oil as necessary to
bring the level to the upper mark on the dipstick.
17. Dispose of used filter and oil properly.