Features and controls, Cab nets – Polaris 2008 Ranger RZR User Manual

Page 42

FEATURES AND CONTROLS

Cab Nets

Upper Cab Net Removal (Driver)

The upper cab net on the driver’s side may be removed only if it inter-

feres with operation of the vehicle. All other cab nets must remain

installed.
1. Using a T-25 torx bit and 7/16"

open end wrench, remove the

mounting screw and washers secur-

ing the upper and lower cab nets to

the floor of the vehicle on the

driver’s side.

2. Reinstall the lower net with the

screw and all washers. Tighten the

screw securely.

3. Unclip the four latches that secure

the upper net to the chassis and

lower net. See the photo on the pre-

vious page.

4. Clip the free upper latch of the

lower cab net to the free latch on

the shoulder net, adjusting strap

length as needed. Tighten the strap.

5. Reverse all steps to reinstall the cab

net.

NOTE:

Always reinstall the upper cab net for any other operator of the vehicle.

Step 1

Screw

and

Washers

Step 2