Polaris 2008 Ranger RZR - Manual (Page 116)

113
MAINTENANCE
Lights
Brake Lights
When the brake pedal is depressed, the brake light comes on. Check the
brake light before each ride.
1. Turn the ignition switch to the ON position.
2. Apply the brakes. The brake light should come on after about 10
mm (0.4 in.) of pedal travel. If the light doesn't come on, check the
bulb.
Vehicle Immersion
If it's impossible to take your vehicle to a dealer before starting it, fol-
low the steps outlined below.
1. Move the vehicle to dry land.
2. Check the air box. If water is present, dry the air box and replace the
filter with a new filter. Thoroughly dry the air pre-filter. See page
101.
3. Remove the spark plugs.
4. Turn the engine over several times.
5. Dry the spark plugs and reinstall them, or install new plugs.
NOTE: Attempt to start the engine. If necessary, repeat the drying procedure.
6. Take the vehicle to your dealer for service as soon as possible,
whether you succeed in starting it or not.
NOTE: If water has been ingested into the PVT follow the procedure on page
100 for drying.
CAUTION
If your vehicle becomes immersed, major engine damage can result if the
machine is not thoroughly inspected. Take the vehicle to your dealer before
starting the engine.