Polaris 2008 Ranger RZR - Manual (Page 60)

57
OPERATION
Starting the Engine
1. Sit in the driver's seat and fasten the seat belt.
2. Place the transmission in PARK.
3. Apply the brakes.
NOTE: Do not press the throttle pedal while starting the engine.
4. Turn the ignition key past the ON/RUN position to START. Engage
the starter for a maximum of five seconds. Release the key when the
engine starts.
5. If the engine does not start within five seconds, return the ignition
switch to the OFF position and wait five seconds. Repeat steps 4
and 5 until the engine starts.
6. Vary the engine RPM slightly with the throttle to aid in warm up
until the engine idles smoothly.
Stopping the Engine
1. Release the throttle pedal completely and brake to a complete stop.
2. Place the transmission in PARK.
3. Turn the engine off.
WARNING
Engine exhaust contains poisonous carbon monoxide and can cause loss of
consciousness resulting in severe injury or death. Never run an engine in an
enclosed area.
CAUTION
Operating the vehicle immediately after starting could cause engine damage.
Allow the engine to warm up for several minutes before operating the vehicle.
WARNING
A rolling vehicle can cause property damage and serious injury. Always place
the transmission in PARK when stopping the engine.