Polaris 2008 Ranger RZR - Manual (Page 54)

51
FEATURES AND CONTROLS
Instrument Cluster
Rider Information Center
Diagnostic Mode
AWD Diagnostic Screen
The gauge indicates whether or not current is flowing through the AWD
coil (only on models with switchable AWD). This screen is for informa-
tional purposes only. Please see your dealer for all major repairs.
Gear Circuit Diagnostic Screen
This screen displays the resistance value (in ohms) being read at the
gear switch input of the gauge. This screen is for informational purposes
only. Please see your dealer for all major repairs.
Programmable Service Interval
When the hours of engine operation equal the programmed service
interval setting, the wrench icon will flash for 5 seconds each time the
engine is started. When this feature is enabled, it provides a convenient
reminder to perform routine maintenance.
The service interval is programmed at 50 hours at the factory. To enable
or disable the service interval:
1. Enter the diagnostic mode. Toggle to the service interval screen.
2. Press and hold the mode switch for about seven (7) seconds, until
either ON or OFF appears in the Rider Information Center, depend-
ing on your preference.
To reset the service interval:
1. Enter the diagnostic mode. Toggle to the service interval screen.
2. Press and hold the mode switch for 2-3 seconds, until the wrench
icon flashes. Release the switch.
3. Press and release the mode switch once to advance the setting by
one hour. Press and hold the mode switch to advance the hours
quickly.
NOTE: If you scroll past the intended number, press and hold the switch until
the hours cycle back to zero.
4. When the desired setting is displayed, wait until the wrench icon
stops flashing. The new service interval is now programmed.