Maintenance, Lights, Headlight beam adjustment – Polaris 2008 Ranger RZR User Manual

Page 115

112

MAINTENANCE

Lights

Headlight Beam Adjustment

1. Place the vehicle on a level surface with the headlight approxi-

mately 25 ft. (7.6 m) from a wall. Place the transmission in PARK.

2. Measure the distance from the floor to the center of the headlight

and make a mark on the wall at the same height.

3. Apply the brakes. Start the engine. Turn on the headlights.
4. Observe the headlight aim. The most intense part of the headlight

beam should be aimed 8" (20 cm) below the mark placed on the

wall in step 2.

NOTE:

Include the weight of a rider on the seat while performing this step.

5. If adjustment is necessary, turn the headlight adjustment screw to

adjust the beam.

6. Repeat steps 4-5 until the beam is properly adjusted.

25 ft.

(7.6 m)

8" (20 cm)