Polaris 2011 Ranger 400 - Manual (Page 102)

98
MAINTENANCE
Cleaning and Storage
Storage Tips
Fluid Levels
Inspect the fluid levels. Add or change fluids as recommended in the
Periodic Maintenance Chart beginning on page 50.
• Front and rear gearcase fluid (if equipped)
• Transmission fluid
• Brake fluid (change every two years and any time the fluid looks dark
or contaminated)
• Coolant (test strength/fill)
Fog the Engine
1. Remove the spark plug and add 2-3 tablespoons (30-45 ml) of
engine oil.
2. Reinstall the spark plug. Torque to specification. See page 64.
3. Apply dielectric grease to the inside of the spark plug cap. Reinstall
the cap.
4. Turn the engine over several times. Oil will be forced in and around
the piston rings and ring lands, coating the cylinder with a protec-
tive film of fresh oil.
5. Treat the fuel system with POLARIS Carbon Clean. See page 97. If
POLARIS fuel system additive is not used, fuel tank, fuel lines, and
carburetor should be completely drained of gasoline.
6. To eliminate any fuel remaining in the carburetor, run the engine
until it stops.
Storage Area/Covers
Be sure the storage area is well ventilated. Cover the vehicle with a gen-
uine POLARIS cover. Do not use plastic or coated materials. They do
not allow enough ventilation to prevent condensation, and may promote
corrosion and oxidation.