Maintenance, Cleaning and storage – Polaris 2011 Ranger 400 User Manual
Page 101

97
MAINTENANCE
Cleaning and Storage
Storage Tips
NOTICE: Starting the engine during the storage period will disturb the
protective film created by fogging and damage could occur. Never
start the engine during the storage period.
Clean the Exterior
Make any necessary repairs and clean the vehicle as recommended. See
page 94.
Stabilize the Fuel
1. Fill the fuel tank.
2. Add POLARIS Carbon Clean Fuel Treatment or POLARIS Fuel
Stabilizer. Follow the instructions on the container for the recom-
mended amount. Carbon Clean removes water from fuel systems,
stabilizes fuel and removes carbon deposits from pistons, rings,
valves and exhaust systems.
3. Allow the engine to run for 15-20 minutes to allow the stabilizer to
disperse through the fuel in the tank and carburetor.
4. Drain the carburetor bowl.
Oil and Filter
Change the oil and filter. See page 58.
Air Filter / Air Box
1. Inspect and clean or replace the pre-cleaner and air filter. See page
73.
2. Clean the air box.
3. Drain the sediment tube.
Inspect and Lubricate
Inspect all cables and lubricate all areas of the vehicle as recommended
in the Periodic Maintenance Chart beginning on page 50.
Battery Maintenance
See pages 91-93 for storage and charging procedures.
- 2010 Ranger 400 HO 2010 Ranger 4x4 2010 Ranger EV 2011 Ranger EV 2011 Polaris EV 2011 Polaris LSV 2011 Ranger 4x4 500 EFI 2011 Ranger Crew 500 EFI 2010 Ranger XP 2010 Ranger HD 2010 Ranger 6x6 2010 Ranger Crew 2012 Ranger Diesel 2011 Ranger Diesel 2014 Ranger Diesel 2014 Ranger Crew Diesel 2011 Ranger XP 800 2011 Ranger 800 HD 2011 Ranger 800 6x6 2011 Ranger 800 Crew 2012 Ranger 400 2013 Ranger 400 Midsize 2013 Ranger 500 Midsize 2013 Ranger Crew 500 2013 Ranger Diesel 2012 Ranger XP 800 2012 Ranger 800 HD 2012 Ranger 800 6x6 2012 Ranger 800 Crew 2013 Ranger 800 2013 Ranger 6x6 800 2013 Ranger Crew 800 2012 Polaris EV 2012 Polaris LSV 2012 Ranger Crew 500 EFI 2012 Ranger 500 EFI 4x4