Polaris 2010 Victory Victory Vision 8-Ball - Manual (Page 111)

107
Pre-Ride
Pre-Ride Inspections
Sidestand
1. On level ground, straddle the motorcycle and bring it to the fully upright position.
2. Move the sidestand up to the stored position and down to the fully extended position sev-
eral times. It should move smoothly and quietly. Make sure the return spring holds the
sidestand tightly in place when the sidestand is in the stored position. Adjust or replace a
loose spring.
3. Inspect the sidestand pivot bolt for
looseness or wear. Tighten or replace
a loose or worn bolt.
4. Inspect the sidestand rubber pad.
Make sure the pad is firmly attached
to the sidestand. Check the wear
indicator on the leading edge of the
pad. Replace the pad when it’s worn
beyond the wear limit line.
Wear Limit
Line
Front of Motorcycle
Pivot Bolt
9922441.book Page 107 Monday, May 11, 2009 1:16 PM