Polaris 2015 INDIAN Scout - Manual (Page 79)

77
Maintenance
Front Brake Lever
1. Lubricate the pivot pin
and brake lever hinge
points at the intervals
recommended in the
periodic maintenance
table beginning on page
56. Also lubricate any
time binding is evident.
Use all-purpose grease.
2. Inspect brake pads as
outlined on page 78.
Front Brake Fluid
Change the brake fluid at the intervals recommended in the
periodic maintenance table beginning on page 56.
Always add brake fluid from a new, unopened container.
Always use the recommended fluid. See page 102.
1. Position the motorcycle on level ground in the fully
upright position. Position the handlebars so that the fluid
reservoir is level. Wipe the fluid container and the area
around the reservoir cover with a clean cloth.
2. If the fluid level is low, inspect brake pads as outlined on
page 78. If pads are not worn beyond the service limit,
inspect the brake system for leaks.
3. To add fluid, remove the reservoir cover screws. Remove
the cover and diaphragm.
4. The fluid level should be above the minimum indicator
mark in the sight glass. Add brake fluid as needed. Do
not overfill.
5. Reinstall the diaphragm, cover and screws.
Torque: 13 in-lbs (1.4 Nm)
6. Wipe away any fluid spills. Check for signs of brake
fluid leaks around hoses, fittings, reservoir and brake
calipers. Check for deterioration of hoses.
Pivot
Pin
Hinge
Sight Glass
Diaphragm
Cover