Polaris 2015 INDIAN Scout - Manual (Page 26)

24
Instruments, Features and Controls
Switches
Hazard Warning Flashers Switch
The ignition switch must be in the ON position to activate the
hazard warning flashers, but once activated, the hazard
warning flashers will continue to flash when the ignition
switch is turned off. When the hazard warning flashers are
active, all four turn signals flash.
• Press and hold the hazard warning flashers switch for 1-2
seconds to activate the hazard warning flashers.
• Press and release the switch to cancel the hazard warning
flashers.
Mode Button
The MODE button is located
on the front side of the left
handlebar controls. With the
ignition switch on, use the
MODE button to toggle
through the modes of the
multi-function display.
Use the MODE button to set
the display units to either
standard or metric units of
measurement. See page 28.
Engine Stop/Run Switch
Use the engine stop/run switch
to turn the engine off quickly.
Turn the key off after the engine
stops.
• Press the top of the switch
(STOP) to interrupt the
circuits and stop the engine.
The engine should not start or
run when the switch is in the
STOP position.
• Press the bottom of the switch
(RUN) to complete the circuits
and allow the engine to start
and run.
Tip: The headlights and any accessories plugged into power ports
will remain on until the ignition key is turned off.
MODE Button
Run
Stop