Polaris 2015 INDIAN Scout - Manual (Page 48)

46
Operation
Priming the Fuel System
If the motorcycle runs out of fuel, prime the fuel system
before attempting to restart the engine.
1. Fill the fuel tank.
2. Turn the ignition key to the ON position.
3. Move the engine stop/run switch to the RUN position.
4. Allow the fuel pump to run until it stops (about 2
seconds).
5. Move the engine stop/run switch to the STOP position.
6. Repeat steps 3-5 four to five times.
7. Turn the key to the OFF position.
8. Start the engine. See page 46.
Starting the Engine
The starter interlock system allows the engine to be started
only when the transmission is in neutral, or when the
transmission is in gear with the clutch disengaged (clutch
lever pulled in).
1. Perform the Pre-Ride Inspections. See page 34. Properly
secure any cargo.
2. Straddle the motorcycle and bring it to the fully upright
position. Retract the sidestand.
3. Turn the ignition key to the ON position.
4. Move the engine stop/run switch to the RUN position.
5. Shift the transmission to neutral.
6. Apply the front brakes. Disengage the clutch (pull the
clutch lever fully toward the handlebar).