Grass Valley PVTV NEWS Rev.4.02 - Manual (Page 23)

19 STUDIO NEWS
Setting Up VTR Play Segments
The VTR Interface provides 8 play segment buttons for each STUDIO-connected VTR.
1
. Select a blank Play Segment
Preset button.
2
. Click the Set Pre-
set button. The Play seg-
ment Setup dialog box
3
. Enter a start-time time
code that corresponds with
the desired play segment.
4
. Enter a stop-time timecode
that corresponds with the
desired play segment.
5
. Enter the name to appear
on the Play Segment Preset
button.
6
. Select OK.
Leave the Duration blank and it will calculate automatically, or enter a duration,
leaving the stop-time blank, and the stop-time will be calculated automatically.
Use the VTR controls to locate the begin-
ning time code. Once found, click the
arrow next to the Start-Time box. Then use the
VTR controls to locate the ending time code,
and click the arrow next to the Stop-time box.
The codes will be entered into the Start/Stop
Time boxes.
To edit or review a saved play segment, select the desired Play Segment Preset
button, click the Set Preset button, clear or edit existing properties, and select
OK to save changes or Cancel to discard changes.