Grass Valley K2 Summit 3G v.8.0 - Manual (Page 78)

3. Click Device Manager
4. Install the first Fibre Channel driver as follows:
a) Right click on the upper Fibre Channel Controller and select Update Driver…
b) On the Welcome page, select No, not this time and then click Next .
c) Select Install from a list or specific location and then click Next .
d) Browse to C:\Profile\Drivers\ Atto 8Gb HBA Drivers\x86 .
e) Click OK .
f) Click Next .
g) Click Finish when prompted.
h) In the Found new hardware wizard that will open for the ATTO Phantom device, select No,
not this time .
i) Select Install from a list or specific location and then click Next .
j) Browse to C:\Profile\Drivers\ Atto 8Gb HBA Drivers\x86 .
k) Click OK .
l) Click Next. .
m) Click Finish when prompted.
5. Repeat the process for the second Fibre Channel Controller as follows:
a) Right-click on the remaining Fibre Channel Controller and select Update Driver…
b) On the Welcome page, select No, not this time and then click Next .
c) Select Install from a list or specific location and then click Next .
d) Browse to C:\Profile\Drivers\ Atto 8Gb HBA Drivers\x86 .
e) Click OK .
f) Click Next .
g) Click Finish when prompted.
6. Verify that the two "ATTO" devices are now listed under the SCSI and RAID Controllers
7. Close the Device Manager and System windows
Using diagnostic tools
Use the following sections as necessary to identify problems.
Running Check Disk
If your K2 Summit 3G system has a critical system fault, you should run Check Disk to identify
and remove any corrupted files.
1. Make sure the K2 Summit 3G system has no media access currently underway.
2. At the MS-DOS command prompt, enter the following and press Enter .
chkdsk
Check Disk reports file system information and lists any problem found.
78 K2 Summit 3G Production Client Service Manual 02 February 2012
Service procedures