Grass Valley K2 Summit 3G v.8.0 - Manual (Page 77)

8. Restore SabreTooth licenses.
9. Activate Windows within 30 days.
Installing the Discovery Agent on a K2 Summit system
If the device that you plan to manage with SiteConfig does not have a SiteConfig Discovery agent
installed, use this topic to verify and, if necessary, manually install SiteConfig support software.
Doing so allows SiteConfig to discover and manage the device. If the device has any version of the
SiteConfig Discovery Agent currently installed, you should use SiteConfig to upgrade the Discovery
Agent, rather than installing it manually.
1. On the device you plan to manage with SiteConfig, open the Windows Services Control Panel
and look for the following required item:
• ProductFrame Discovery Agent
2. Proceed as follows:
• If you find the required items, no further steps are necessary. SiteConfig support software is
installed.
• If a required item is not present, navigate to your SiteConfig files. If you do not already have
these files in convenient location, you can find them on the PC that hosts SiteConfig, in the
SiteConfig install location. Then continue with next steps as appropriate.
3. To launch the program that installs the ProductFrame Discovery Agent Service do the following:
a) Copy the Discovery Agent Setup subdirectory to the device.
b) In the Discovery Agent Setup directory, double-click the
DiscoveryAgentServiceSetup.msi file.
The setup program launches to install the SiteConfig Discovery Agent.
c) Follow the setup wizard.
4. When presented with a list of device types, select one of the following as appropriate:
• K2SummitSanClient
• K2SummitStandaloneClient
5. Complete the setup wizard and restart the device.
The restart is required after the installation.
Installing the ATTO Fibre Channel card driver
Before installing the Fibre Channel card driver, make sure that K2 software is installed and the write
filter is disabled. Also, if the K2 Summit system is on a redundant K2 SAN or is connected to
direct-connect storage, make sure that MPIO software is installed.
If your K2 Summit system has the optional Fibre Channel card, the driver for the Fibre Channel
card is not installed on the recovery image provided by Grass Valley for that K2 Summit system.
Therefore, after restoring the image, you must install the Fibre Channel card driver.
1. Open Device Manager.
2. Right-click on K2 Summit Client and select Manage.
02 February 2012 K2 Summit 3G Production Client Service Manual 77
Service procedures