Grass Valley K2 Summit 3G v.8.0 - Manual (Page 55)

5. Repeat the previous steps until you have determined which adapter name goes to which (PCI
bus X, device 0, function X) location.
Next, name adapters.
Name adapters
Before doing this task, you must know the (PCI bus X, device 0, function X) location of adapters.
1. If K2 software is installed, disable the write filter, if it is not already disabled.
2. Open Network Connections, if it is not already open.
3. In Network Connections, identify the adapter names and enumerators that the Windows operating
system has assigned to adapters.
4. Determine which adapter names in the Device name column are assigned to which (PCI bus X,
device 0, function X) location.
5. Reconcile the locations assigned to the adapter names with the names as currently configured in
the Name column.
The required mapping of names to locations is specified in the following table:
Must be named as follows: The adapter name (as displayed in the Device
Name column) that is assigned to this location…
Control Connection #1 PCI bus 4, device 0, function 1
Media Connection #1 PCI bus 4, device 0, function 0
Media Connection # 2 PCI bus 3, device 0, function 0
Control Connection #2 PCI bus 3, device 0, function 1
02 February 2012 K2 Summit 3G Production Client Service Manual 55
Service procedures