Grass Valley K2 Summit 3G v.8.0 - Manual (Page 76)

Next, check the adapter names and order. If adapter names and order are not as documented, restore
network configuration.
Restoring settings after generic reimage
This task assumes that you have saved settings using ssave.bat before reimaging the K2 Summit
3G system, and that the reimage (Acronis) process is complete.
1. If you have not already done so, start up the K2 Summit 3G system and log on with administrator
privileges.
The administrator password is adminGV! .
2. Connect the USB Recovery Flash Drive to a USB port on the K2 Summit 3G system.
3. From the USB Recovery Flash Drive, run the following and wait for the process to complete:
srestore.bat
4. If desired, name the computer (My Computer).
You can copy the name from C:\README.txt .
5. Run the following:
C:\WINDOWS\NewSid\newsid.exe
The New SID wizard opens.
6. In the New SID wizard, do one of the following:
• To allow the wizard to assign a new, random SID to the K2 Summit 3G system, select Random
SID .
• To retain the SID that the K2 Summit 3G system had before reimaging, select Specify SID .
Refer to C:\README.txt to get the SID and instructions on entering the SID.
7. In the New SID wizard, select Rename the computer to: and enter the computer name.
8. Click Next to complete the wizard.
The K2 Summit 3G system restarts.
Next, do the following as appropriate to restore your K2 Summit 3G system. Refer to related topics
in this document or as otherwise indicated.
1. Restore network configuration. If you saved settings with ssave.bat , refer to C:\ipconfig.txt
for the complete listing of the network settings that the K2 Summit 3G system had before
reimaging.
2. Check the Windows operating system clock, and if necessary, set it to the correct time.
3. Install K2 software and SNFS software. If you saved/restored settings with
ssave.bat and
srestore.bat , SNFS uses the restored settings. Refer to related topics in "K2 Release Notes".
4. Install the SiteConfig Discovery Agent.
5. If the K2 Summit system has a Fibre Channel card, install the Fibre Channel Card driver. Refer
to related topics in this document.
6. If a K2 Summit system with direct-connect storage or shared storage on a redundant K2 SAN,
install MPIO software.
7. If a K2 Summit SAN-attached system, on the K2 SAN’s control point PC, use the K2Config
application to add the K2 Summit system back to the SAN
76 K2 Summit 3G Production Client Service Manual 02 February 2012
Service procedures