Grass Valley K2 FCP Connect v.2.0.0 - Manual (Page 48)

• For access to a K2 SAN, you should use K2Config, rather than the K2 FCP GV
Connect Preferences, to change the licensing server.
Stopping and starting the K2Config for Mac service
1. Close GV Connect, if it is currently open.
2. In System Preferences open K2 FCP GV Connect .
3. Click the Tools tab.
4. To start the K2Config for Mac service, click Start and then enter username and
password with administrator privileges.
5. To stop the K2Config for Mac service, click Stop , when prompted "...Are you
sure..." click Yes , and then enter username and password with administrator
privileges.
6. To view any recent status change, click Refresh Status .
When you stop the K2Config for Mac, the service is stopped permanently, even
after the Macintosh system is restarted. Once you have stopped the service, you
must re-start it manually.
Accessing logs
1. Close GV Connect, if it is currently open.
2. In System Preferences open K2 FCP GV Connect .
3. Click the Tools tab.
48 K2 FCP Connect Installation Manual 22 October 2010
Using and maintaining K2 FCP Connect