Grass Valley K2 FCP Connect v.2.0.0 - Manual (Page 16)

Comment Task
detects and displays K2 storage that
is mounted as a volume on the
Macintosh system.
Check GlobalSuperUser setting. Verify SNFS configuration file and
configure if necessary.
Refer to the K2 System Guide. Configure K2 SAN HotBin to receive
finished Final Cut Pro files.
The Aurora system must be
operational and available to the
Macintosh system. If using an Aurora workflow,
configure your Aurora system.
Final Cut Pro on stand-alone K2 system quick start installation
checklist
Use the following sequence of tasks to set up Final Cut Pro to access a stand-alone
K2 Media Client, stand-alone K2 Summit Production Client, or K2 Solo Media Server.
This checklist assumes that the K2 system has been installed/commissioned and is
fully operational.
Prerequisites
Comment Task
— Verify K2 SAN, Macintosh, and Aurora
system requirements as applicable.
On the stand-alone K2 system
Comment Task
Make the license request early to ensure
that the license file is received and Request a K2 FCP Connect license
from Grass Valley for the stand-alone
K2 system.
installed before attempting to complete
the installation process. If there is no
shortcut on the desktop use the
procedure "If you encounter difficulties
when requesting a license" from release
notes.
— When the license XML is received,
install it on the stand-alone K2 system.
— Enable the Grass Valley
SabreToothWS service.
16 K2 FCP Connect Installation Manual 22 October 2010
Installing and configuring K2 FCP Connect