Grass Valley K2 FCP Connect v.2.0.0 - Manual (Page 14)

Final Cut Pro on K2 SAN quick start installation checklist
Use the following sequence of tasks to set up Final Cut Pro on a K2 SAN with Fibre
Channel SCSI access or Gigabit iSCSI access. This checklist assumes that the K2
SAN has been installed/commissioned and is fully operational.
Prerequisites
Comment Task
— Verify K2 SAN, Macintosh, and
Aurora system requirements as
applicable.
On all Macintosh client computers
Comment Task
— Install Final Cut Pro, if not already
installed.
Xsan must be installed before K2 FCP
Connect. Install Xsan software, if not already
installed.
The software install file is
K2FCPConnect.pkg .
NOTE: Before installing the
software, you must be logged in as a
Install K2 FCP Connect software.
user with administrative privileges
on the domain.
— Cable network connections, including
Fibre Channel, if used.
— Configure for control network, if not
already done.
Copy in host table information from
the K2 SAN's hosts file. Configure the hosts file for
networking.
This is optional. If you do this task,
you must also enable Access Control
Lists on the K2 Media Server (FSM). Optional: Configure Active Directory
Domain
14 K2 FCP Connect Installation Manual 22 October 2010
Installing and configuring K2 FCP Connect