Grass Valley K2 FCP Connect v.2.0.0 - Manual (Page 34)

8. Identify software installed on the client device and proceed as follows:
• If any software with Yes in the Required column reports as Not Installed, you
must install it on the client device. After installing the software, click Check
Software.
• If all software with Yes in the Required column reports as Installed, click Check
Software.
When all required software reports as Installed, continue with the next step in
this procedure.
9. Click Next .
The SabreTooth Server Configuration page opens.
10. Enter the K2 Media Server (FSM) as follows:
• If a basic (non-redundant) K2 SAN, enter the media file system K2 Media
Server as primary.
• If a redundant K2 SAN, enter primary and backup media file system K2 Media
Servers.
11. Click Next .
The Network Configuration page opens.
This page configures both control and media (iSCSI) network connections. The
top port is the port over which the K2 System Configuration application is
34 K2 FCP Connect Installation Manual 22 October 2010
Installing and configuring K2 FCP Connect