Grass Valley Fiber Media Converter - Manual (Page 38)

38 Media Converters — Instruction Manual
Installation and Operation
You may assign a new IP address to the unit in the System IP Address field. To
assign a new IP address, first write down the new address you will be using
then type the new number in the field. Verify the address is correct, then
press
Enter .
This will bring up the message shown in Figure 28 . You will need to power
cycle the unit to apply the new IP address.
Figure 28. IP Address Change Message
Clicking on a TX or RX module on the main monitoring web page will bring
up a status web page similar to
Figure 29 on page 39 for the TX module and
Figure 30 on page 39 for the RX module.
The module type and status is reported in the upper left corner. The slot
number of the module is reported at the top of the page.
The following read-only status information for each module is reported as
applicable for the module type:
• Slot location
• Serial Number
• Part Number
• Revision Number
• Manufacturing Date
• Data Rate
• Part Temperature
• Laser Bias Current
• Transmit Optical Power
• Received Optical Power
• TX Fault Indicator
• Cable Detect Indicator
• Loss of Signal
• Reclocker Lock (VMC modules only)