Grass Valley Fiber Media Converter User Manual
Page 31
Media Converters — Instruction Manual
31
Installation and Operation
To install a VMC or MVMC module in either frame type, follow the instruc-
tions below:
Note
For ease of installation, it is recommended that slots are populated from left
to right to allow room for easier access to the Mini-XLR power connectors.
3.
Install a TX or RX module in either frame type by first plugging the
male Mini-XLR type connector on the module into an open female
Mini-XLR type power receptacle in the frame (
). (The plugs
and receptacles are keyed so that they cannot be improperly installed.)
4.
Once the Mini-XLR connector (power) has been mated, connect the
BNC on the module to the appropriate BNC bulkhead in the frame. The
appropriate bulkhead connector is slightly above the selected
Mini-XLR connector when viewing the frame as shown in
Figure 19. Installing VMC Modules
5.
Install a MVMC module in the same manner as shown in
.
Figure 20. Installing MVMC Module
Install male Mini-XLR
on module to female
Mini-XLR to BNC relationship
Mini-XLR connector
in frame.
Install BNC connector
on module to appropriate
BNC connector in frame.
Dust plug
Dust plug