Grass Valley Fiber Media Converter User Manual
Page 29
Media Converters — Instruction Manual
29
Installation and Operation
6.
After removing the two screws, carefully snap off the extended length
rear bracket (
).
Figure 17. Extend Length Rear Bracket Removed
7.
Determine where to reinstall the extended length rear bracket so it is the
correct length for your rack and snap it back on.
8.
Reinstall the two screws in two of the positions provided but do not
fully tighten rear bracket mounting screws until final adjustment is
made. Install the screws as far apart as possible for strength.
Rack Mounting
To install the frame in the rack, follow the instructions below:
1.
Insert the guide pins provided in the additional parts into the middle
hole of each of the four brackets (see instruction pamphlet for
illustration).
2.
Insert the frame into the rack using the guide pins to position the
brackets in the correct locations.
3.
Fully extend the rails. The guide pins will support the slide while the
rack screws are attached.
4.
Once the rack is in place and in the correct position, tighten the inside
screws on the extended length rear bracket.