Configure media frame ask: register components, Chapter 3 configuring the aurora transfer system – Grass Valley Aurora Transfer v.6.0b User Manual
Page 26
26
Aurora Transfer Instruction Manual
September 11, 2006
Chapter 3 Configuring the Aurora Transfer System
Configure Media Frame ASK: Register components
For the conventions mentioned in the following table, refer to
http://localhost:280
MediaFrameCore
ASK
Open this configuration page locally on the Aurora Transfer server machine.
All Domain names in the Aurora Transfer system must be identical.
Port 9010 is required. See
“Ports and services mapping” on page 20
Saves changes. Changes are lost if you leave the configuration page without
updating.
For the following settings, use the table below. Add each MDI and/or Encoder
required by your system
Click to add an MDI.
Lists currently added MDIs.
Checks MDIs.
Deletes the currently selected MDI.
Always click
Update…
buttons after making changes
To put changes into effect, start or restart the ASK service on the Aurora Transfer
server.
When you add an MDI
logical name for this
type of machine/
device…
Select “MDI/
Encoder Type”…
Enter “MDI/
Encoder
Name”…
Enter “Host Name or IP”…
Enter “Port”… Comments
A K2 Storage System
a
K2
As per
convention.
Hostname of the machine hosting the
K2 MDIs. Typically the MDI Server.
9160 - 9169
These are process ports, as
explained in
numbers in an intentional
sequence, so they are easy to match
in
.
K2 Media Client -
Internal storage
(stand-alone)
K2
Open SAN Profile
b
Profile
As per
convention.
Hostname of the machine hosting the
Profile MDIs. Typically the Transfer
Server
9130 - 9139
These are process ports, as
explained in
numbers in an intentional
sequence, so they are easy to match
in
.
Stand-alone Profile
Profile
M-Series
MSeries
As per
convention.
Hostname of the machine hosting the
M-Series MDIs. Typically the
Transfer Server
9140 - 9149
These are process ports, as
explained in
numbers in an intentional
sequence, so they are easy to match
in
.