Grass Valley Aurora Transfer v.6.0b - Manual (Page 20)

20 Aurora Transfer Instruction Manual September 11, 2006
Chapter 3 Configuring the Aurora Transfer System
Ports and services mapping
Aurora Transfer software components run as Windows services, which communicate
over designated ports. As you configure the Aurora Transfer system, you must
correctly designate port numbers. Topics later in this manual provide specific
instructions for entering port numbers on each configuration page. These are the
default port numbers. Do not modify or create your own convention for port usage
without consulting Grass Valley. Designate ports as specified in the following table:
The Aurora Transfer system also depends upon Microsoft Internet Information
Services (IIS) and SQL services, which are installed on the Transfer Server.
Services Port Comments
Thomson Ask 9010 —
Thomson Asset Manager 9022 and 9023 —
Thomson Avalon Archive
MDI 9120 —
Thomson DIVA MDI 9122 —
Thomson FlashNet MDI 9124 —
Thomson Metadata 9014 Not visible on a configuration page
Thomson MSeries MDI 9140 The service manages a number of host processes, one for each M-Series
iVDR that is being managed. These host processes require ports 9140 -
9149. Stopping/starting the service stops/starts all of the host processes.
Thomson K2 MDI 9160 The service manages a number of host processes, one for each K2
system that is being managed. These host processes require ports 9160
- 9169. Stopping/starting the service stops/starts all of the host
processes.
Thomson News MDI 9150 —
Thomson NTFS MDI 9115 —
Thomson Profile MDI 9130 The service manages a number of host processes, one for each Profile
that is being managed. These host processes require ports 9130 - 9139.
Stopping/starting the service stops/starts all of the host processes. The
version 1.5 default port number for these processes was 8022, with no
range
Thomson Proxy MDI 9110 —
Thomson Resolver 9016 Not visible on a configuration page