Grass Valley 8990ARC v.3.0 - Manual (Page 46)

46 8990ARC Instruction Manual
Specifications
Specifications
Table 10. 8990ARC Specifications
Parameter Value
SDI Input
Signal type SMPTE 259M-C or EBU tech 3267, 8- or 10-bit serial digital component
video
Number of inputs 1 loop-through
Connector type 75 Ω BNC
Return loss > 15 dB, 5 to 270 MHz
Max input cable length 300 m (1000 ft.) of Belden 8281 or equivalent
SDI Outputs
Number of outputs 4
Connector type 75 Ω BNC
Signal type SMPTE 259M-C or EBU tech 3267
Output impedance 75 Ω
Return loss > 15 dB, 5 to 270 MHz
Signal Processing
Signal path 12-bit processing internally then rounded and truncated to 10 bits
525/625 selection Automatic
Aspect ratio selection 16:9 to 4:3, 4:3 to 16:9, manual or automatic if video index is enabled
Modes 16:9 to 4:3 conversion • Bypass (No processing)
• Letterbox (no loss)
• Full height (h-crop)
• 14:9 sub-image (some h-crop, less than full height)
Modes 4:3 to 16:9 conversion • Bypass (No processing)
• Pillarbox side panels (no loss)
• Full width (v-crop)
• 14:9 sub-image (some v-crop, less than full width)
Horizontal position Left/center/right justified output (shrink) or input (magnify)
Vertical position Top/center/bottom justified output (shrink) or input (magnify)
Horizontal ancillary data All horizontal embedded ancillary data (HANC) passed to output
Hot switch handling Module will handle input signal hot switched between synchronous sig-
nals that are timed within 1/2 line without causing glitches in the output
stream
Switching line processing None
Vertical interval blanking Vertical interval lines: Lines 1-20, 264-283 (525)
Lines 624-23, 311-336 (625)
These lines are blanked if the VANC Data control is set to Blanked. These
lines are passed if the control is set to Pass.