Grass Valley 8985PRC v.1.1.0 - Manual (Page 43)

8985PRC — Instruction Manual 43
Configuration
Video Out Web Page
Use
this
link
Use the Video Out web page ( Figure 21 ) to enable or disable the SFP Fiber
Optic submodule outputs when present and set the horizontal video delay
on the video output.
Note Fiber optic outputs will be present when either a Dual Transmitter (TX1 and
TX2) or a Transceiver (TX2) Fiber Optic submodule is installed.
Output Enables
This section provides the following for the video output signal:
• Fiber TX1 – check the Enabled checkbox to enable the output (Dual Trans-
mitter fiber optic submodule installed).
• Fiber TX2 – check the Enabled checkbox to enable the output (Dual Trans-
mitter or Transceiver fiber optic submodule installed).
SD/HD Video Delay (pixels)
The horizontal video delay can be adjusted in 1.0 pixel steps for HD video
and 0.5 pixel steps for SD video.
Figure 21. Video Output Web Page