Grass Valley 8985PRC v.1.1.0 - Manual (Page 23)

8985PRC — Instruction Manual 23
Configuration
Remote Configuration and Monitoring
8985PRC module configuration and monitoring must be performed
remotely using a web browser GUI interface or a networked Newton
Control Panel when the 8900NET Network Interface module is present in
the GeckoFlex frame. Each of these interfaces is described below.
Note The local configuration switches are present but not active on this module.
8900NET Module Information
Refer to the 8900NET Network Interface Module Instruction Manual for infor-
mation on the 8900NET Network Interface module and setting up and
operating the GeckoFlex frame network.
Note The 8900NET module in the GeckoFlex frame must be running software
version 4.3.0 or higher for proper remote and control panel operation.
Upgrade software and instructions for the 8900NET can be downloaded from
the Grass Valley web site.
Newton Control Panel Configuration
A Newton Control Panel (hard or soft version) can be interfaced to the
GeckoFlex frame over the local network. Refer to the documentation that
accompanies the Newton Modular Control System for installation, config-
uration, and operation information.
Control panel access offers the following considerations for module config-
uration and monitoring:
• Ability to separate system level tasks from operation ones, minimizing
the potential for on-air mistakes.
• Ability to group modular products—regardless of their physical loca-
tions—into logical groups (channels) that you can easily manipulate
with user-configured knobs.
• Update software for applicable modules and assign frame and panel IP
addresses with the NetConfig Networking application.
• Recommended for real-time control of module configuration parame-
ters, providing the fastest response time.
Note Not all module functions are available with the control panel, such as E-MEM
and factory default recalls. The available control panel controls for the
8985PRC module are listed in
Table 6 on page 53 .
An example of the Newton Configurator is shown in Figure 7 on page 24 .