Grass Valley 8985PRC v.1.1.0 - Manual (Page 17)

8985PRC — Instruction Manual 17
Installation
Cabling
Cabling is done on the rear BNCs of the 8900GFR-R module illustrated in
Figure 5 . Inputs and outputs are also illustrated on the I/0 Config web page
( I/O Config Web Page on page 32 ).
Figure 5. 8900GFR-R Rear Module
Video Inputs
Connect an HD or SD digital video signal to the Coax input at BNC J9,
and/or to one or both of the fiber inputs at fiber connector J10 (depending
on the type of fiber submodule installed).
Note Refer to Table 3 on page 47 for important video input and external genlock
reference input video frame rate compatibility information.
For fiber optic inputs, a Dual Receiver or Transceiver SFP optical sub-
module must be installed. Fiber inputs must be enabled with remote con-
trols. Only one video input can be used at a time and must also be selected
with remote controls.
8666_01r1
8900GFR-R
Fiber Optic Cabling
FIBER
J1 J2
J3 J4
J5 J6
J7
J9
J8
J9: Coax In
J5: SDI Out
Fiber Rx 1
Fiber Tx 2
Fiber Rx 2
J7: SDI Out J8: SDI Out
Fiber Inputs/Outputs
(See Fiber Optic Cabling
at right.)
J6: SDI Out
Not Used Not Used
Not Used Not Used
SFP-13103G-M1DRX
SFP-13103G-M1DTX
SFP-13103G-M1TRX
Fiber Tx 1
Fiber Rx 1
Fiber Tx 2