Grass Valley 8985PRC v.1.1.0 - Manual (Page 34)

34 8985PRC — Instruction Manual
Configuration
System Config Web Page
Use
this
link
Use the System Config web page ( Figure 14 on page 35 ) to set the following
system configuration parameters for the module:
Input Video
Use the following controls to set the video input type and rate. Refer to
Table 6 on page 53 for a complete list of available input types and rates.
• Input Type – select the radio button corresponding to the input type.
• Input Rate – select the desired input rate from the pulldown.
Pressing the Defaults button or changing the Input Type from HD to SD on
the System Config web page or with an E-MEM recall will cause the
module to reboot. It will take approximately 30 seconds to re-initialize.
During this time a Wait Page (
Figure 13 ) will appear. Wait for the operation
to complete then select the Refresh button to update the web page.
Figure 13. Wait Page
Test Output
An internally generated colorbars test signal may be enabled on the output
of the module by checking the
Enabled checkbox. Be sure to disable this
output before going on-air.
Split Screen
Use a horizontal or vertical split screen to compare the unprocessed input
video (top or right) to the processed output video (bottom or left). This
control is duplicated and tied together with the Split Screen controls on the
Color Correction and Video Proc web pages. Changes made on any one of
the Split Screen controls will control all three screens.
• Split Enable – enable the split screen by checking the Split Enabled
checkbox.
• Orientation – select the orientation of the split screen with the Vertical or
Horizontal radio button.
Refresh button