Grass Valley 8985PRC v.1.1.0 - Manual (Page 13)

8985PRC — Instruction Manual 13
Installation
Rear Module Installation
To install the rear module, refer to Figure 2 and the instructions below:
1. To remove a blank rear adapter cover (or a rear module already
present), manually loosen the two screws holding each retainer clip on
the rear adapter cover or rear module to the frame with the retainer clip
tool provided inside the front cover of the frame (newer model frames
only) or a 2 mm (5/64”) hex screwdriver. Do not remove the screws.
1. After loosening the retainer clip screws, pull up on each retainer clip
and completely remove it, leaving the screws in place.
2. Remove the blank rear adapter cover by inserting needlenose pliers
into the slots in the blank cover and pulling it off.
3. Insert the rear module into the empty slot, guiding it carefully into
place.
4. Replace each retainer clip over the two screws on both sides of the
module and push down to seat the retainer clip.
5. Tighten the two screws on each retainer clip just until they come into
contract with the retainer clip then tighten about a 1/4 turn more
(snug). The retainer clip screw maximum torque specification is
4-5 inch-lb/0.45-0.6Nm. The retainer clips should not bend or be
bowed.
Note All unused rear slots in a GeckoFlex frame should have a blank rear adapter
cover installed.
Figure 2. Installing Rear Module (751- Version Frame Shown)
8444
23r0