Grass Valley 8985PRC v.1.1.0 - Manual (Page 32)

32 8985PRC — Instruction Manual
Configuration
I/O Config Web Page
Use
this
link
Use the I/O Config web page ( Figure 11 ) for the following:
Rear Connectors
All of the input and output connectors on the corresponding 8985PRC rear
module are illustrated on the I/O Config web page. BNCs J1, J2, J3, and J4
are not used for this module.
The inputs can be configured with the following controls:
• Signal Naming – type the desired input name (up to 11 characters) into the
corresponding boxes for each input. Each signal has a default name. To
recall default factory names, refer to
Recall Factory Defaults and Names on
page 40 . The status of each input is indicated by the color of the display.
• Reporting Enabling – status reporting of each input type can be enabled or
disabled by selecting or deselecting the corresponding checkbox in the
Reporting Enabled column for each input type. You may disable reporting
for inputs not being used if desired to avoid error messages. The
Reporting Enabled column is also used when an SNMP monitoring appli-
cation such as NetCentral is installed.
Refer to on page 48 for an explanation of the color coding and using an
SNMP monitoring application.
Note Outputs are not monitored in this application.
Figure 11. 8985PRC I/O Config Web Page