Grass Valley 8949SVM-LOC - Manual (Page 28)

28 8949SVM-LOC/-UMD—Instruction Manual
Networking the 8949SVM
Access Through a DHCP Enabled Network
1. Enable the DHCP mode with the paddle switch controls and restart the
board by selecting the Unit reset with the paddle switch controls.
2. Connect the module to a network hub or switch using a standard RJ-45
Ethernet cable.
3. The unit will be assigned an IP address by the DHCP server.
4. To locate this address, scroll to the Status control group using the paddle
switch controls then enter the Status control group by pressing the Menu
paddle switch control up. Use the Up and Down paddle switch controls
to scroll to the Current IP address and note what IP address the unit has
been assigned by the DHCP server.
5. When the IP address setup is complete, go directly to Updating Software
on page 29 .
Forcing a Default IP Address
1. Disable the DHCP mode using the paddle switch controls and restart
the board by selecting the Unit reset with the paddle switch controls.
2. The default IP address can be forced to the module by using the paddle
switch controls as described in
Table 1 on page 20 and described in step
by step detail in Set Default IP, IP Net Mask and Default Gateway on
page 24 .
3. The current IP address can be checked by selecting the Status control
group and scrolling through the values with the paddle switch controls.
4. When the IP address setup is complete, go directly to Updating Software
on page 29 .