Grass Valley 8949SVM-LOC - Manual (Page 13)

8949SVM-LOC/-UMD—Instruction Manual 13
Introduction
Front Module Installation
After installing the rear module, install the front module as follows:
1. Remove the front cover of the frame if required.
2. Locate the corresponding front slot.
3. Insert the front module so that the plastic card guides on the module
top and bottom edges go over the upper and lower raised rail guides on
the right of the top and bottom of the slot (
Figure 2 ).
4. Carefully slide the module into the rear connector on the rear module.
5. Lock the front module ejector tab into the locking pin.
CAUTION This module must be installed in a GeckoFlex frame with front cover fans
(8900FF/FFN). Keep the front cover on the frame at all times after installation
and configuration to insure proper cooling.
Figure 2. Front Module Installation
8436_04
Slide top and bottom card carriers on module
over top and bottom guides on right of slot.
Module installed
Locking Pin
Card Carriers
Card Carriers
Front Module Side View