Grass Valley 8949SVM-LOC - Manual (Page 21)

8949SVM-LOC/-UMD—Instruction Manual 21
Module Configuration and Monitoring
Control Settings
Pattern Pattern/Off Off, Bars, Pluge, Pluge M Select Off or one of three test patterns.
Safe area markers Safe area/Off Off, 16:9, Protect 4:3 Select Off or safe area markers on monitor.
UMD select UMD Select/Disable Enabled or Disabled
8949SVM-UMD only. See UMD Text and Tally
Control on page 37 .
Auto image width Auto width/Enabled Enabled or Disabled Image width is adjusted automatically.
Manual image width Manual width/100
50 to 120
(in steps of 1)
Adjust width of image manually.
Anamorphic SD Anamorphic/Disabled Enabled or Disabled
When enabled, compensates for 16:9 SD images
transmitted in the anamorphic format.
Pulse cross Pulse cross/Disabled Enabled or Disabled
Enabled shows horizontal and vertical blanking
view.
Tally left Tally left/Off Off, Red Green
8949SVM-UMD only. See UMD Text and Tally
Control on page 37 .
Tally right Tally right/Off Off, Red, Green
Initial Settings
Display Size Size (HxV)/Auto
Refer to Table 2 on
page 33 .
When set to Auto, optimum monitor resolution will
be auto-sensed. User can select resolutions below
optimum. When attempts to select resolution
above optimum, monitor will report: Cannot dis-
play this mode
and switch to optimum resolution.
Frame rate Frame/Follow input 60Hz
Follow Input 60 Hz,
Follow Input,
Monitor rate
Select output frame rate as one of three choices:
Follow Input 60Hz:
Output will always be 59.94 or 60Hz and will
phase lock to the input frame rate if possible. 50Hz
inputs will be converted to 60Hz prior to display.
Follow Input:
Output will be 50Hz for 50/25Hz inputs and
60/59.94Hz for the corresponding inputs. Output
will frame lock to input if possible. Refer to
Table 3
on page 34 for delay lengths relative to input for-
mat.
Monitor rate:
This mode uses more information from the display
device and should be used if the above modes do
not give a correctly positioned image.
Display drive Display drive/DVI DVI or RGB
Refer to DVI-I Connector on page 14 for cabling
descriptions and using DVI or VGA monitor.
Power save Power save/Disabled Enabled or Disabled
When enabled, if no SDI input is detected for 5
seconds, the unit will disable the DVI output caus-
ing the display to enter a power saver state.
DHCP DHCP/Disabled Enabled or Disabled
Refer to UMD Text and Tally Control on page 37 for
networking details.
IP net mask IP net mask/255:255:255:0 (text edit)
Default IP address Default/192.168. 0.200 (text edit)
Default gateway Gate/192.168. 0. 1 (text edit)
IP multicast Mult/232.2. 3. 2 (text edit)
Refer to UMD Text and Tally Control on page 37 for
using multicast functions.
ID multicast ID multicast/0 0 to 126
Unit reset Restart – Reset unit, user settings remain as programmed.
Table 1. 8949SVM Paddle Switch Configuration Table
Control Group Control Name Menu Name/Default Range/Options Description