Grass Valley 8949SVM-LOC - Manual (Page 24)

24 8949SVM-LOC/-UMD—Instruction Manual
Networking the 8949SVM
Set Default IP, IP Net Mask and Default Gateway
Change any of the network addresses if required as described below. This
example will show how to change the
Default IP address from 192.168. 0.200
to 10. 16. 18. 59. The other network addresses are changed in the same
manner.
1. Press the Menu paddle switch control down until you reach the Status
control group.
2. Use the Up or Down paddle switch controls to scroll to the Initial Settings
control group.
3. When you reach this group, press the Select paddle switch control up to
enter the menu group. The Display Size menu is the first selection.
4. Now use the Up or Down paddle switch controls to scroll to the Default IP
Address menu and enter this menu by pressing the Select paddle switch
control up.
5. In the Default IP address menu, the first set of numbers in the Default IP
address menu will be surrounded by brackets (<192>168. 0.200)
indicating they can be changed (from 0 to 255) using the
Up and Down
paddle switch controls.
6. Make the required change to the first set of numbers and when finished,
press the
Select paddle switch control up. This will enter the new values
and move the brackets to the next set of numbers ( 10<168> 0.200)
indicating these may now be changed.
7. Set the second set of numbers using the Up and Down paddle switch
controls and when finished, press the Select paddle switch control up to
enter these numbers and move to the next set (10.16< 0>.200.
8. Do the same for the third set of numbers and press the paddle switch
control up to enter this value and move to the last set (10.16.18<200>).
9. Once you have set the last set of numbers and the display reads
10. 16. 18. 59, press the
Select paddle switch control up to enter this
address into the module.
10. Now, press the Menu paddle switch control down to leave the Default IP
address menu.