Grass Valley 8947RDA-D - Manual (Page 44)

44 8947RDA-D/-FR — Instruction Manual
Remote Configuration
8947RDA-FR Settings Web Page
Use
this
link
The Settings web page for the 8947RDA-FR provides configuration of coax
and optional fiber optic inputs and outputs and reporting of signal status.
The parameters for configuration of a 8947RDA-FR module are explained
below:
Routing Mode
The Routing Mode configuration will be different depending on the presence
and type of fiber optic SFP device options installed.
• Coax and Fiber Optic Inputs – The available inputs to the module depend on
the presence and type of fiber optic SFP device. Choose one of the avail-
able inputs from the list below. Only one input can be selected at a time.
• Coax In 1 – J9 BNC coax input is always enabled and available (only
choice when a fiber optic SFP device is not installed).
• Fiber Optic In RX1 or RX2 – Two optical inputs are available when a
Dual Receiver (SFP-13103G-M1DRX) fiber optic SFP device option
is installed. These inputs are always active and available.
• Fiber Optic Input RX1 – One fiber optic in put is available and active at
RX1 when a Transceiver fiber optic SFP device
(SFP-13103G-M1TRX) is installed.
• Fiber Optic Outputs TX1 and TX2 – Two fiber optic outputs are available when
a Dual Transmitter (SFP-13103G-M2DTX) fiber optic SFP device option
is installed. One fiber optic output is available at RX2 when a Trans-
ceiver fiber optic SFP device is installed.
Fiber outputs must be enabled by selecting Enable or Disable in the Fiber
Outputs control.
Note Only an SFP-13103G-M2DTX model Dual Transmitter can be used on the
8947RDA-FR module.
Other Settings and Reporting
I nput Reporting – choose between Enable or Disable . The Enable parameter sends
alarms to the 8900NET module on the input signals (presence of signal).
The color of arrows on the module Status web page will be automatically
changed.
The Disable parameter will change the color of arrows on the Status web
page to gray to show they are not being monitored or reported to upper
level control devices.
Equalizer Mode – Set the equalizer to Active or Bypass .