Grass Valley 8947RDA-D - Manual (Page 18)

18 8947RDA-D/-FR — Instruction Manual
Installation
Optional Fiber Optic SFP Device Installation (8947RDA-FR)
After the front and rear modules have been installed, install the optional
Fiber Optic SFP device if being used on the 8947RDA-FR module, into the
metal cage labeled FIBER (
Figure 5 on page 19 ) accessible from the
8900WFR-R rear module. The SFP device is hot-pluggable and may be
installed or removed with power applied to the module.
CAUTION Use anti-static precautions and handle the SFP device carefully when
installing and the removing it. Before inserting the fiber cable, it is important
to clean all fiber connections as described in Fiber Optic Cleaning Require-
ment below.
Refer to Table 3 for the correct model of SFP device to use with different
software versions of the 8947RDA-FR module.
Fiber Optic Cleaning Requirement
Before making any fiber optic cable mating connections, including installa-
tion, and after every de-mating cycle, use an industry standard fiber optic
cleaning kit, including oil-free compressed air, to clean the fiber connectors
and the connectorized fiber end faces. This helps ensure optimum perfor-
mance of the fiber optic interface. Industry standard fiber optic cleaning
kits can be purchased on the web and in electronics stores.
Table 3. Fiber Optic SFP Device Summary
SFP Device Type SW 1.3.1 and later SW 1.3.1 and earlier
SFP-13103G-M1DRX Dual Receiver X –
SFP-13103G-M2DTX 1
1 The only Dual Transmitter SFP device model that can be used on the 8947RDA-FR is the SFP-13103G-M2DTX.
Dual Transmitter X –
SFP-13103G-M1TRX Transceiver X –
1310nm-DRL Dual Receiver X X
1310nm-DTL Dual Transmitter X X
1310nm-TRL Transceiver X X