8947rda-d settings web page – Grass Valley 8947RDA-D User Manual
Page 33
8947RDA-D/-FR — Instruction Manual
33
Remote Configuration
8947RDA-D Settings Web Page
Use
this
link
The Settings web page for an 8947RDA-D (
) provides
controls for configuring and reporting status of DA signals.
The
Routing Mode
area allows selecting the outputs for DA1 and DA2.
•
Coax In 1
– Selection of J9 BNC coax input feeds outputs J1, J3, J5, J7.
•
Coax In 2
– Selection of J10 BNC coax input feeds outputs J2, J4, J6, J8.
Note
Coax In 1
or
Coax In 2
can be configured to feed all eight outputs
for using the module as a single DA.
Coax Signal Names
– Signal names can be entered for Coax Input J9 and Coax
Input J10. These names will be recognized for SNMP reporting.
Other Settings and Reporting
Input Reporting
– Choose between
Enable
or
Disable
. The
Enable
parameter
sends alarms to the 8900NET module on the input signals (presence of
signal). The color of arrows on the module Status web page will be auto-
matically changed.
The
Disable
parameter will change the color of arrows on the Status web
page to gray to show they are not being monitored or reported to upper
level control devices.
Equalizer Mode
– Set the equalizer to
Active
or
Bypass
.
Reclock Mode
– Set the reclock mode to
Auto
or to the specific data rate:
•
Auto (disables
Signal Format
selection)
•
143Mb/s
•
177Mb/s
•
270Mb/s
•
360Mb/s
•
540Mb/s
•
1485Mb/s
•
ASI
Signal Format
– Select the signal format as
SD/ASI
or
HD
. This setting will be
grayed out as
N/A
when
Auto
Reclock Mode is selected.
Carrier Detect
– Reports if the module detects a valid carrier as
Present
or
Not
Present
.
Locked Rate
– Reports the data rate the module is locked to or if it is not
locked reports
Not Locked
or
N/A
.