Grass Valley 8947RDA-D - Manual (Page 24)

24 8947RDA-D/-FR — Instruction Manual
Power Up
Power Up
The on-board LED indicators are illustrated in Figure 8 . Upon power-up,
the green PWR LED should light and the CONFIG, FAULT and COMM
LEDs should illuminate during the module initialization.
Note When a module is first plugged into a GeckoFlex frame, the 8900NET module
(if present) may report a momentary fault. This will clear once the module has
booted up.
Operation Indicator LEDs
With a valid input signal connected, the Channel 1 PRES SIG LED EQ
(input to BNC J9), OPT 1, and/or OPT 2 (depends on presence and type of
fiber optic SFP device) should be on. Refer to
Table 6 on page 25 to see a
complete list of possible operating conditions and the resulting indicator
status.
Note LEDs shown for color only, not status. Channel 2 Monitoring Mode LEDs are
not used at this time.
Figure 8. Front Module Indicator LED