Front module configuration, Local configuration – Grass Valley 8947RDA-D User Manual

Page 14

8947RDA-D/-FR — Instruction Manual

Installation

Front Module Configuration

If you have an 8900NET module (Net Card) in your frame and will be con-
figuring the module remotely with a web browser or the Newton Control
Panel, you may configure and monitor the module remotely over the
network with the web browser.

If you do not have an 8900NET module in the GeckoFlex frame for remote
monitoring and configuration, you will need to configure the module using
the local onboard controls before installing it in the frame.

Do this configuration before installing the front module into the frame.

Local Configuration

Local configuration of either model 8947RDA consists of two DIP switches
(S1 and S2) highlighted in the lower left corner of

Figure 3

. Refer to

Table 1

on page 15

for configuring the 8947RDA-D and for

Table 2 on page 16

for

configuring the 8947RDA-FR.

Figure 3. Configuration Switches on 8947RDA-D/-FR Modules