Led status reporting – Grass Valley 8900NET v.4.4.0 User Manual
Page 30
30
8900NET (Net Card) — Instruction Manual
Status Monitoring and Reporting
LED Status Reporting
LEDs on the 8900NET module, media modules in the frame, and on the
front cover of the Gecko (8900TF/TFN-V/-A) and GeckoFlex
(8900FF/FFN) frames indicate fault status of the frame and the installed
power supplies, fans in the front covers, and front media modules.
When the red FAULT LED is lit on an 8900NET module the fault will also
be reported on the frame front cover. The LEDs on the front of the 8900NET
module can then be read to determine the following frame and module
fault conditions:
•
Power Supply 1 and 2 health,
•
Fan rotation status,
•
Frame over-temperature condition,
•
Frame Bus fault (8900NET only), and
•
Module health Bus status.
In general, LED colors used on the frame and modules indicate:
•
Green – normal operation, (Pass) or signal present, module locked.
•
Red – On continuously = fault condition, flashing = configuration error.
•
Yellow – On continuously = active condition (configuration mode or
communication), flashing in sequence = module locator function.
Status LEDs for the 8900NET module are shown in
and described in
. LEDs for the Frame Monitor module
that comes in the 8900TF-V/TF-A or 8900FF frames are described in the
Gecko 8900 Frames Instruction Manual or the GeckoFlex Frames Instruction
Manual.
Status reporting to the LEDs on the front of the 8900NET card can be dis-
abled if desired on the LED Reporting web page. Refer to the
for complete details.