Grass Valley 2040RDA-16FR - Manual (Page 31)

2040RDA-FR/16FR — Instruction Manual 31
Configuration and Adjustments
Settings Web Page
Use
this
link
The Settings web page provides the controls for the module depending on
the type of submodule installed. Select the
Apply button after each selection
to activate the choices. Also use the Refresh button to update the changes.
Coax Input/Output Settings (No Submodule)
With no submodule installed, the Settings web page ( Figure 22 ) will
provide the following controls for the module:
• Mode – set the reclocking mode to one of the following with the Mode
pulldown:
• Auto ASI – set to ASI default mode for most multiple applications for
auto detection of the relocking rate. If the signal cannot lock, it will
bypass reclocking automatically. DVB-ASI signals are supported in
this mode, while 177M signals are not.
• Auto 177M – set to 177M default mode for applications where specific
rate requirements are needed to differentiate from ASI. If the signal
cannot lock, it will bypass reclocking automatically. 177M signals
are supported in this mode, while DVB-ASI signals are not.
• Bypass – reclocking is completely bypassed.
• Reclk 143M , Reclk 177M , Reclk 270M , Reclk 360M , Reclk 540M , or
Reclk 1485M – set the module to lock to a specific reclock rate. If the
signal cannot lock to the selected rate, the output will be invalid.
Figure 22. Coax settings Web Page (No SPF Module)